Index    Main     General     Rifles    50 BMG     SMG     MG    AR    Contact    Links    Measuring

Aligning and Centering a Muzzle Mounting Suppressor


centerin.GIF (11623 bytes)

This is the usual method of aligning a suppressor mounted on muzzle thread. The suppressor aligns itself against the relief cut shoulder, which must be lathe-turned perpedicular to the bore axis. Missalignment will cause deterioration of accuracy or even damages to suppressor due to bullet grasp to baffles.

Suppressor aligning procedure is needed only when mounting it, from then on it will keep the alignment when properly used. Please avoid overtightening - this will cause unnecessary wear to aligning surfaces. Do not shoot with loose or untightened suppressor, as this may damage it!

Telescopic suppressors do not need aligning, because they support themselves from two points against the barrel. These instructions do not apply to conical thread, bayonet or other special means of suppressor mounting.

MX Minireflex Suppressor


Kalashnikov Reflex Suppressor KRS

MX12 pistol suppressor


Index    Main     General     Rifles    50 BMG     SMG     MG    AR    Contact    Links    Measuring